 |
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
|
| If you can't view the Datasheet, Please click here to try to view without PDF Reader . |
|
|
| Datasheet File OCR Text: |
| RF AMPLIFIER MODEL CZ8040 Features ! ! ! ! Lower Cost Lower Noise Figure: < 3.8 dB Typical Operating Temp. 0 C to +70 C Environmental Screening Available Available as: CZ8040, 3 Pin TO-39 TN8040, 4 Pin Surface Mount (SM3) BX8040, SMA Connectorized Housing (H1) Typical Intermodulation Performance at 25 C Second Order Harmonic Intercept Point ....... +32 dBm (Typ.) Second Order Two Tone Intercept Point ........ +26 dBm (Typ.) Third Order Two Tone Intercept Point ............ +21 dBm (Typ.) Specifications CHARACTERISTIC Frequency Gain (dB) Power @ 1 dB Comp. (dBm) Reverse Isolation (dB) VSWR In Out Noise figure (dB) Power Vdc mA TYPICAL Ta= 25 C kHz - 400 MHz 19 +9.5 -21 <2.0:1 <2.2:1 <3.8 +3.5 25 MIN/MAX Ta = 0 C to +70 C kHz - 300 MHz 18 Min. +6.0 Min. -20 Max. 3.0:1 Max. 2.5:1 Max. 4.5 Max. +3.5 Min. 28 Max. Maximum (No Damage) Ratings Ambient Operating Temperature .............. -55C to + 100 C Storage Temperature ............................... -62C to + 125 C Case Temperature ................................................. + 125 C DC Voltage ........................................................... + 6 Volts Continuous RF Input Power ................................... + 8 dBm Short Term RF Input Power ...... 50 Milliwatts (1 Minute Max.) Maximum Peak Power ................... 0.5 Watt ( 3 sec Max.) *Three external capacitors and a decoupling impedence are required. The decoupling impedance must be large in comparison to the 50 Ohm load to minimize gain reduction. The external capacitors determine the low frequency response of the amplifier. *Decoupling Impedance is 1 kOhm. Note: Care should always be taken to effectively ground the case of each unit. Typical Performance Data Gain (dB) 21 20 19 18 17 Start kHz Stop 400 MHz 0 - 10 - 20 - 30 - 40 Start kHz Reverse Isolation (dB) 6 5 4 3 2 Stop 400 MHz Start kHz Noise Figure (dB) Stop 400 MHz 1 dB Comp. (dBm) +12 +10 +8 +6 +4 Start kHz Stop 400 MHz 3.0 2.0 1.0 Start kHz Input VSWR 2.5 1.75 1.0 Stop 400 MHz Start kHz Output VSWR Stop 400 MHz Legend +25 C +70 C - - - - - - 0 C Spectrum Microwave * 2144 Franklin Drive N.E. * Palm Bay, Florida 32905 * PH (888) 553-7531 * Fax (888) 553-7532 3/30/04 www.SpectrumMicrowave.com Spectrum Microwave (Europe) * 2707 Black Lake Place * Philadelphia, Pa. 19154 * PH (215) 464-4000 * Fax (215) 464-4001 |
Price & Availability of CZ8040
 |
|
|
|
|
All Rights Reserved © IC-ON-LINE 2003 - 2022 |
| [Add Bookmark] [Contact Us] [Link exchange] [Privacy policy] |
|
Mirror Sites : [www.datasheet.hk]
[www.maxim4u.com] [www.ic-on-line.cn]
[www.ic-on-line.com] [www.ic-on-line.net]
[www.alldatasheet.com.cn]
[www.gdcy.com]
[www.gdcy.net] |